Amprobe AT-4000 Advanced-Wire-Tracer Manual de usuario descargar pdf (Pagina 10)

APPLICATION NOTES

Using the R-4000 Receiver

1.Turn the R-4000 ‘ON’ by pressing the Power ON/OFF push button.

2. Select the ‘High’ sensitivity by pressing the sensitivity push button(LED ‘ON’).

3. Select the appropriate mode by pressing the MODE push button (LED ‘ON’:Open

tracing; LED ‘OFF’: Short tracing)

4.If the indication on the display is too strong (7-10 LEDs), change the sensitivity level

to MID (LED ‘blinking’).

IMPORTANT: Always conclude your tracing with the “MID” or “LOW” sensitivity

because the built in detector has a 360˚ detection range. It will be a good idea to have

the transmitter on the low signal transmission depending on the length of the wire you

are tracing.

5.When tracing, move the R-4000 back and forth slowly over the path of the wire.The

strongest signal confirms the path of the wire.

Fig.9 R-4000 Receiver

In either SHORT or

OPEN MODE, the unit is

non position sensitive

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Amprobe AT-4000 Advanced-Wire-Tracer Manual de usuario Pagina 10