Amprobe BT-120 Breaker-Tracer Manual de usuario descargar pdf (Pagina 8)

OPERATION

Breaker and Fuse Identication

1. Plug the transmitter into an energized 120V wall outlet. Refer to Fig.1.

2. Make sure the red LED is ON to indicate that the outlet is energized.

3. Push the Power switch on the receiver to turn it ON. The receiver will beep

and the Power LED will be lit.

4. At the breaker panel or fuse box, hold the receiver perpendicular to the

breakers. Scan slowly all breakers once to calibrate the receiver.

During this scan, the receiver may beep and ﬂash at several breakers. This is a

normal part of the identiﬁcation process. Refer to Fig.2

5. Without touching the ON/OFF button,Start the scan another time to identify

the right breaker or fuse. When the receiver beeps, the correct breaker has

been identiﬁed.

6. Push and Hold the Power Switch for three (3) seconds to turn the receiver

off. Beeping and ﬂashing during the shutdown is normal.

7. Unplug the transmitter from the wall outlet.

Fig. 1

Fig. 2

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Amprobe BT-120 Breaker-Tracer Manual de usuario Pagina 8