Amprobe TIC-300-PRO Non-Contact-Voltage-Detector Manual de usuario descargar pdf (Pagina 11)

OPERATION

ON / OFF Button

When the TIC 300 PRO is activated, the blue LED’s and

beeper will pulse at a slow rate about twice a second.

The red LED of the range (HIGH) will turn ON.

TEST Button

The TEST button should be used prior to testing actual

power circuits. The TEST function will cause the blue

LEDs to pulse at a continuous rate and the beeper tone

to stop either on LOW or HIGH mode.

OSHA listed clearance distances for working with

voltage. National or local requirements may be

different.

Line voltage (kV) Phase to ground Phase to phase

phase to phase (ft-in) (m) (ft-in) (m)

0.03 to 1.0 note1 note note1 note1

1.1 to 15.0 2-1 0.64 2-2 .66

15.1 to 36.0 2-4 0.72 2-7 0.77

36.1 to 46.0 2-7 0.77 2-10 0.77

46.1 to 72.5 3-0 0.90 3-6 1.05

72.6 to 121 3-2 0.95 4-3 1.29

Note1. – No contact necessary

Caution: If a three phase circuit is being checked and

one phase is open, the voltage from another phase

maybe detected and will give a faulty indication.Always

make sure that the phase cables are separated by at least

15”(381mm)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 91 92

Sin comentarios

Amprobe TIC-300-PRO Non-Contact-Voltage-Detector Manual de usuario Pagina 11