Amprobe ACD-400 Especificaciones descargar pdf (Pagina 10)

OPERATION

AUXILIARY FEATURES Push Button

°F/°C/R/e Button (ACD-23SW only) °F/°C/R/e

Use the “°F / °C “ button to select the °F or °C Temperature ranges.

Use the “R/e“ button to select the Resistance or Continuity ranges

HOLD.

HOLD Button

Data hold freezes the reading present on the LCD at the moment the button is

pressed.To use this menu feature, set up the meter for the type of measurement

and range desired.

Connect the test leads to the circuit / component to be measured and then press

“HOLD” push button. The LCD reading will freeze and display “HOLD”. You may

now remove the test leads and the reading will not change until you press Hold

again.

RANGE Push Button

This function allows the user to select the range of a function that does not show

“RANGE” on the LCD.

BACKLIGHT Button

Backlight auto-off approx. 60 sec.

Auto Power Off (APO)

This meter will automatically turn the power off after 10 minutes. To disable the

APO, set the meter to off position, press and hold the (

BACKLIGHT) button

while turning the rotary knob to the desired range position. Release the button

when LCD displays normally. Note “APO” annunciator is missing from the LCD.

Measuring DC Voltage

1. Set the Function Switch to L

2. Connect the test leads: Red to +, Black to COM.

3. Connect the test probes to the circuit test points. Refer to Fig.1

4. Read the display. If necessary, correct any overload (OL) conditions.

Measuring AC Voltage

1. Set the Function Switch to K.

2. Connect the test leads: Red to +, Black to COM.

3. Connect the test probes to the circuit test points. Refer to Fig.2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

Amprobe ACD-400 Especificaciones Pagina 10