Amprobe Multitest-1000 Continuity-Tester Manual de usuario descargar pdf (Pagina 38)

Note: If the START/STOP key was pressed and held, the instrument takes more

consecutive tests.

5. When a new value is acquired the instrument emits a short sound and calculates the

new average value.

6. Press DISP key to show how many measurements are in average value

calculation and the measuring mode.

DISP

7. Press CLR key if you want to cancel the medium value of the resistance

and the number of measurements which are included in the calculation.

CLR

Example: if the operator takes three consecutive measurements, the instrument displays

measurement:

main display = measured resistance value (Ex: 0.90Ω)

secondary display on the left-hand side = 001 (no. of measurements = 1

means that 1 earth measurement has been taken)

secondary display = average of the measurements taken (in case just one

measurement has been taken the medium value is equal to the measured

value, in this case 0.90Ω)

measurement:

main display = measured resistance value (Ex: 0.96Ω)

secondary display = average of the measurements taken ((Val1+Val2)/no.

of measurements = (0.90+0.96)/2 = 0.93Ω)

measurement:

main display = measured resistance value (Ex: 0.93Ω)

secondary display = average of the measurements taken ((Val1+Val2)/no.

of measurements = (0.90+0.96+0.93)/3 = 0.93Ω)

Note

: Any test with result over 1999Ω is not inserted in the calculation of medium value.

Example: 1

measurement:

main display: 1,07Ω

secondary display: 1,07Ω

measurement

main display: 4,15Ω

secondary display: 2,61Ω

measurement (not inserted in the medium value)

main display: >1999Ω

secondary display: 2,61Ω

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 121 122

Sin comentarios

Amprobe Multitest-1000 Continuity-Tester Manual de usuario Pagina 38